Owner's Manual
Table Of Contents
- User Guide
- Reset
- Demo Mode
- Table of Contents
- Features
- Supplied Accessories
- Commander Touch Connections
- Install the Commander Touch Display Controller
- Install the Commander Touch Tuner Module
- Install the Magnetic Mount Antenna and Route the Antenna Cable
- Install the Wiring
- Subscribe
- Update the Commander Touch Software
- Using Commander Touch
- Settings
- Troubleshooting
- Specs
13
Commander Touch User Guide
CAUTION! Don’t mount
the antenna close to
another antenna. Mount
it at least 3 inches away.
Route the Antenna Cable
Before you begin routing the antenna cable, read these general instructions for how to route and hide
the antenna cable. Then route your antenna cable according to the step-by-step instructions which
follow for your specific type of vehicle.
Use care when routing the antenna cable into and through the vehicle interior, avoiding sharp objects
that can damage the cable. Keep the antenna cable away from moving parts such as gas, clutch,
and brake pedals, trunk and door hinges, and sliding seat brackets. Hide the antenna wire inside the
vehicle cabin by routing the cable under the carpet and behind plastic trim, toward the Tuner Module
location. Coil and secure any excess cable in a hidden location, such as under the carpet, using wire
ties (not included). CAUTION! Do not kink or sharply fold the antenna cable.
Feed cable under
rubber moulding
around window
Tuck the cable under the
moulding around the window
Use a blunt plastic putty knife, a credit card,
a plastic knife, or a similar blunt tool to lift the
rubber window moulding
Introduction