Owner's Manual
Table Of Contents
- User Guide
- Reset
- Demo Mode
- Table of Contents
- Features
- Supplied Accessories
- Commander Touch Connections
- Install the Commander Touch Display Controller
- Install the Commander Touch Tuner Module
- Install the Magnetic Mount Antenna and Route the Antenna Cable
- Install the Wiring
- Subscribe
- Update the Commander Touch Software
- Using Commander Touch
- Settings
- Troubleshooting
- Specs
18
Commander Touch User Guide
Pickup Truck
1. Use a blunt plastic putty knife or similar blunt tool to lift the rubber molding around the
windshield and tuck the antenna cable underneath it.
2. Continue tucking the cable underneath the windshield molding around the windshield to the
lowest corner.
3. At the lowest corner of the windshield, route the cable out of the windshield molding and into the
rubber weather stripping around the door opening. Lift the weather stripping from the opening
and tuck the cable inside it, then replace the weather stripping. Run the
cable inside of the weather stripping to the bottom of the door opening.
4. Pull the cable out of the weather stripping at the bottom of the door
opening and route it under the carpet toward the dashboard. Coil any
excess cable in a hidden location, such as under the carpet, keeping it
away from any vehicle pedals or controls. Secure the excess cable with
wire ties.
5. Bring the end of the cable out at the PowerConnect Vehicle Dock
location. Leave yourself enough cable so you can easily connect it to the
antenna connector of the dock.
6. Connect the antenna connector to the ANT connection of the Tuner Module. Note: Use only
SiriusXM approved antennas.
Antenna
Introduction