Owner's Manual

Commander Touch User Guide

update, the process cannot be interrupted.

6. You can provide uninterrupted power to your Commander Touch for the duration of the

software update.

Software Update Instructions

Commander Touch must remain on during the entire software update process. If power is

interrupted during the software update process your Commander Touch will become damaged.

1. Go to www.siriusxm.com/commandertouch and download the software update file. This file will

be named SXVCT1_SW_Update_vxx.xx.xx.zip. (xx.xx.xx is the software version number.)

2. Open the ZIP archive and extract the software update file(s) to a folder on your computer. They

will be named SXVCT1_S.xxx and/or SXVCT1_N.xxx.

3. Copy any files you may have off of your USB Flash Drive to another location, and then erase or

reformat (FAT32) the USB Flash Drive. Copy the SXVCT1_S.xxx and/or SXVCT1_N.xxx file(s) to

the root directory of the USB Flash Drive. Do not put them in a folder on the drive.

4. You will need access to the USB port on the bottom of the Display

Controller. If the Display Controller is mounted in the Flush Mount,

remove the Display Controller from the Flush Mount using the

Release Tool. Center the tool on the right side and press in between

the Display Controller and the Flush Mount until the latch releases.

(You may need to rock it gently from side to side slightly to release

the latch.) Then pry the Display Controller out of the Flush Mount.

5. Turn your Commander Touch on. This may require you to

turn the ignition in your vehicle to ACC to provide power

to Commander Touch. Wait until Commander Touch is

completely powered on.

6. Connect the USB Flash Drive to the USB port on the

bottom of the Commander Touch. Use the adapter or

adapter cable, if necessary.

7. Swipe to Settings, swipe up or down if necessary, tap

the About button, and swipe up to the second page.

8. If the software update only included the file named

SXVCT1_S.xxx, tap DCU/DLP Software Update. If the

software update only included the file named

SXVCT1_N.xxx, tap NAND Image Update. If the software

update included both files, perform the DCU/DLP

Software Update first, and then repeat this procedure to

perform the NAND Image Update.

9. You will be prompted to begin the software update. Tap

Update to proceed.

10. If there are any problems in reading the file on the USB

Flash Drive, you will be alerted by an advisory message,

and the software update will be aborted.

Micro USB Port

Step 7Step 9Step 9

Introduction