Owner's Manual
Table Of Contents
- User Guide
- Reset
- Demo Mode
- Table of Contents
- Features
- Supplied Accessories
- Commander Touch Connections
- Install the Commander Touch Display Controller
- Install the Commander Touch Tuner Module
- Install the Magnetic Mount Antenna and Route the Antenna Cable
- Install the Wiring
- Subscribe
- Update the Commander Touch Software
- Using Commander Touch
- Settings
- Troubleshooting
- Specs

37
Commander Touch User Guide
2. Tap the number buttons 0-9 to enter the channel number and wait a moment until the channel
is tuned, or tap the Go icon to immediately tune to the channel.
3. You will be prompted to enter the lock code. Enter
the lock code and tap Go.
4. If you have entered the correct lock code the
channel will be tuned.
Note that all locked channels are now unlocked, and will
remain unlocked until you power Commander Touch off
and on again.
Also refer to “Directly Tuning Channels” on page 32.
To Tune a Locked Channel from the Channel/Category List
1. Tap the Channel/Category List icon.
2. Tap the Channels/Categories button in the upper right corner to toggle between numerical
order or category order for the channel list.
3. Tap and drag up and down to scroll through the channel list. If you are in category list mode, tap
and drag left or right to change categories.
4. Once you have found the locked channel you want
to tune to, indicated by the lock icon
, tap the
channel in the list.
5. You will be prompted to enter the lock code. Enter
the lock code and tap Go.
6. If you have entered the correct lock code the
channel will be tuned.
Note that all locked channels are now unlocked, and will remain unlocked until you power
Commander Touch off and on again.
To Tune a Locked Channel from Favorites
1. In the Swipe Area, swipe to Favorites, swipe up or down if necessary, and tap a locked favorite
channel. Locked channels have a red border around the favorite channel button.
2. You will be prompted to enter the lock code. Enter
the lock code and tap Go.
3. If you have entered the correct lock code the
channel will be tuned.
Note that all locked channels are now unlocked, and will
remain unlocked until you power Commander Touch off
and on again.
Forgotten Lock Code
If you have forgotten your lock code, it can be cleared by performing a factory reset. A factory rest
will clear the lock code, turn off Channel Lock, and clear all locked channels. Refer to “Factory Reset”
on page 52.
Commander Touch Features