Owner's Manual

46
Commander Touch User Guide
Software Update
SiriusXM may occasionally release a system software
update for Commander Touch. The update can be
installed by connecting a USB Flash Drive with the
software update to the micro USB port located at the
bottom of the Display Controller.
Refer to “Step 6: Update the Commander Touch
Software” on page 24 for detailed instructions on how
to update the software.
FM
FM is used when your Commander Touch has been installed using the FMDA25 FM Direct Adapter.
The FM setting allows you to turn the FM transmitter on and off, and to set and select FM channels
and presets. Note that if there is no connection to the FM output of the Tuner Module, when you tap
FM and advisory will tell you There is no connection to FM out.
Creating FM presets is an easy way to change FM channels if you encounter any audio interference.
You can preselect 4 FM channels, and then easily switch between them with a tap. Remember that
when you change the FM channel that you also need to set your vehicle’s FM radio to the same FM
channel.
Turning the FM Transmitter On or Off
1. In the Swipe Area, swipe to Settings, swipe up or
down if necessary, and tap FM.
2. Tap the button at the lower left toggle between FM
On and FM Off.
3. When you turn FM off, an advisory will tell you that
the audio is enabled through the AUX output. Tap
the OK button.
When you turn FM on, an advisory will tell you the
FM channel, and to set you vehicle radio to the
same FM channel. Tap the OK button.
4. Tap the Back icon in the upper left corner to exit.
Settings