Owner's Manual

52
Commander Touch User Guide
Factory Reset
Factory Reset restores Commander Touch back to the factory settings. All configuration changes will
be reset, the lock code deleted, and all favorite channels deleted.
1. In the Swipe Area, swipe to Settings, swipe up or
down if necessary, and tap Factory Reset.
2. You will be prompted to confirm that you want
to proceed with the factory reset. Tap Restore to
proceed or tap Cancel if you changed your mind
and do not want to proceed with the factory reset.
3. A confirmation screen will verify that Commander
Touch has been reset to the factory settings. Tap
Continue and you will be returned to the main
display screen.
Demo Mode
Demo Mode is a demonstration of several of the features and display screens of Commander Touch.
Demo mode starts automatically when, for a period of time (approximately one hour), Commander Touch
detects it’s not connected to the antenna, or the antenna stops receiving a signal. Demo mode ends when
the antenna is connected properly or when a signal is received again.
If desired, you can also manually put Commander Touch in demo mode. You can exit demo mode at any
time by tapping the main display screen.
The ability for Commander Touch to enter demo mode is enabled by default. If you don’t want
Commander Touch to automatically enter the demo mode, you can disable the demo feature and
enable it again at another time if desired.
Turning the Demo Mode On and Off
1. In the Swipe Area, swipe to Settings, swipe up or
down if necessary, and tap Demo Mode.
2. Tap Demo Mode On/Off to toggle between On and
Off.
3. Tap the Back icon in the upper left corner to exit.
Manually Entering Demo Mode
1. In the Swipe Area, swipe to Settings, swipe up or
down if necessary, and tap Demo Mode.
2. Tap Enter Demo Mode.
3. You will be advised that Commander Touch is
Settings