Owner's Manual
Table Of Contents
- User Guide
- Reset
- Demo Mode
- Table of Contents
- Features
- Supplied Accessories
- Commander Touch Connections
- Install the Commander Touch Display Controller
- Install the Commander Touch Tuner Module
- Install the Magnetic Mount Antenna and Route the Antenna Cable
- Install the Wiring
- Subscribe
- Update the Commander Touch Software
- Using Commander Touch
- Settings
- Troubleshooting
- Specs
7
Commander Touch User Guide
Commander Touch Connections
Display Controller Connections
Display Controller Pigtail Cable: Connects to the DISP connection on the Tuner Module.
Micro USB Port: SiriusXM may occasionally release a system software update for Commander Touch.
The update can be installed by connecting a USB Flash Drive with the software update to the micro
USB port located at the bottom of the Display Controller. A micro USB Flash Drive or a USB type A
Flash Drive with a USB type A to Micro USB Adapter is required (not included).
Tuner Module Connections
ANT (Antenna): Connection for the Magnetic Mount Antenna.
FM: Connection for the FMDA25 FM Direct Adapter.
AUX (Auxiliary audio output): Connection for the AUX Audio Cable.
PWR (Power): Connection for the Wiring Harness.
DISP (Display): Connection for the Display Controller pigtail cable.
Tuner Module
Left Side View
ANT FM AUX PWR DISP
Right Side View
Display Controller Bottom View
Micro USB Port
Display Controller
Pigtail Cable
Introduction