Owner's Manual

9
Commander Touch User Guide
3. Once the opening has been cut, remove the
template and place the Flush Mount in the
opening. The Flush Mount is asymmetrical so
the top/bottom orientation is not important.
4. Bend each of the two Mounting Brackets
into a U shape. If needed, the ends of the
Mounting Brackets can be trimmed using
metal shears to accommodate thicker dash
material.
5. Attach the Mounting Brackets to the rear
of the Flush Mount, using the provided 4
screws. Position the legs of the Mounting
Brackets against the inside of the dash or
console surface and tighten the screws. Note
that you may need to bend or cut the ends
of the mounting brackets depending on the
specific application.
Alternate Mounting Method: If the above
mounting method does not work in your
particular installation, the Mounting Brackets
can also be attached to the Flush Mount
by using the center threaded hole in the
Mounting Bracket, and the tabs on bent as
necessary for the installation. The Mounting
Brackets can also be trimmed using a shears
to accommodate the installation.
Attach the Mounting Brackets using a screw
through the front of the Flush Mount to the
Mounting Bracket at the rear of the Flush
Mount.
Introduction