Owner's Manual

1
Dash Mount Method:
IMPORTANT: The air temperature needs to be at least 60°F to install the Dash Mount. If needed, turn on the heater in your vehicle.
A. Select a flat surface for the Dash Mount with ample room for the Roady BT display. Avoid
mounting on leather surfaces. Choose a location that doesn’t interfere with the driver’s vision or access to driving controls, one that won’t interfere with the deployment of airbags or other safety equipment, and makes the Roady BT display easily accessible for operation. (Airbag locations are typically marked with “SRS” logos.)
B. Orient the adhesive foot so that Roady BT is easily accessible. Loosen the knob and adjust the
adhesive foot to position 1, 2, or 3, and then tighten it.
C. You can tilt the Dash Mount in your preferred direction. D. Remove the adhesive liner from the back of the Magnet
and adhere the adhesive side of the Magnet to the Dash Mount.
E. Clean the mounting surface in the vehicle with the alcohol
preparation pad and let it dry thoroughly.
F. Once the surface is dry, remove the adhesive liner from the Dash
Mount. Press and hold the Dash Mount in place for 30 seconds. Allow the adhesive to cure for 2-4 hours.
G. Attach the Roady BT Display to the magnet on the Dash Mount.
Vent Mount Method:
A. Select a vent with ample room for the Roady BT display, one that won’t interfere with the deployment
of airbags or other safety equipment, and makes the Roady BT display easily accessible for operation. (Airbag locations are typically marked with “SRS” logos.)
B. Some vents have recessed louvers. If yours are recessed, remove the regular vent clamps and
install the extended vent clamps.
C. Remove the adhesive liner from the back of the Magnet
and adhere the adhesive side of the Magnet to the Vent Mount.
D. Install the Vent Mount onto the vehicle vent.
i. Insert the vent mount into the vent opening. ii. Push until hooked on the rear of the vent louver. Rest the foot against the bottom of the vent. iii. If necessary, adjust the tilt of the Vent Mount by repositioning the foot to a different tilt
adjustment hole.
E. Attach the Roady BT Display to the magnet on the Vent Mount.
Find a Location for the Roady BT Display and Mount it
1
2
3
1
Select either the Dash Mount method or the Vent Mount method for mounting the Roady BT, or, if there is a metal surface in the vehicle, the Magnet can be attached directly to the metal surface without using the
Dash or Vent Mount. Other magnetic type mounts may also be purchased separately from other vendors.
Start Here
PUSH
I II III
Dash
Dash
Dash
Vent
Louver
Vent
Vent
HOOKED
TILT
ADJUSTMENT
HOLES
FOOT
Knob Adhesive Foot
Option 1 Option 2 Option 3
Mounting Surface
for Magnet
Round End Orientation
Vent Mount Rear View
Slide Left Clamp to
Hole in Center
Pull Clamp Out
Towards You
Insert Round End
of the Extended
Clamp in the
Center Hole
Slide Clamp to Left
to Complete
Installation
Repeat to Replace
Right Clamp