User guide

3 Before you attach the Vent Mount to the vent, skip ahead and finish

the remainder of the vehicle installation so that the cables are

attached to the dock.

Note! For greater clarity, the next illustration does not show the dock

attached to the Vent Mount, however, the dock should be attached before

continuing.

4 Once the cables have been attached to the dock, push the Vent

Mount onto the vehicle vent as shown (1) until it hooks on the rear of

the vent louver (2).

5 Rest the foot against the bottom of the vent (2), and adjust the tilt

of the Vent Mount by repositioning the foot to a different adjustment

hole (3).

To remove the Vent Mount, push the mount into the vent. Then lift up until

disengaged from the rear of the vent louver, and remove the Vent Mount.

PUSH

Dash

Vent

Louver

Foot

Vent

Dash

HOOKED

TILT

ADJUSTMENT

HOLES

1 2 3

Vehicle Installation