Operating Instructions
Table Of Contents
- Table of contents
- 1 Dear Customer,
- 2 General data
- 3 General description
- 4 Safety
- 5 Installation and startup
- 5.1 Transport and unpacking
- 5.2 Disposal of packaging materials
- 5.3 Installation site
- 5.4 Commissioning
- 5.4.1 Functional elements
- 5.4.2 Supplied tools
- 5.4.3 Touch display description
- 5.4.4 Illumination of the processing chamber, LED light strip, and On/Off button
- 5.4.5 Using the processing chamber screen
- 5.4.6 Installation
- 5.4.6.1 Connecting to the PC via LAN
- 5.4.6.2 Connecting the unit to the power supply
- 5.4.6.3 Installing the unit
- 5.4.6.4 Connecting the suction device (optional)
- 5.4.6.5 Connecting to the PC via WLAN (option)
- 5.4.6.6 Operating several production units at one access point
- 5.4.6.7 Connecting to the PC via the wireless interface (optional)
- 5.4.7 Filling the water tank
- 5.4.8 Switching the unit ON and OFF
- 5.5 Repacking
- 5.6 Scope of supply
- 5.7 Storage
- 6 Operation
- 7 Service
- 7.1 Using the cleaning hose and the wet cleaning process
- 7.2 Changing filter bags and HEPA filters
- 7.3 Changing the water
- 7.4 Instruments
- 7.5 Care, cleaning agents, and disinfectants
- 7.6 Cleaning surfaces
- 7.7 Replacing the main fuses
- 7.8 Changing the filter
- 7.9 Removing water from the unit
- 7.10 Using the tank cap opener
- 8 Technical description
- 9 Disposal
- 10 Consumable
- Index
Dentsply Sirona
Operating Instructions CEREC Primemill
5 Installation and startup
5.5 Repacking
67 19 756 D3439
D3439.201.01.01.0209.2019
39
Ä If no hub is found in the network, you can manually enter the IP
settings.
4.
Confirm the date and time.
5.
Activate the suction settings if necessary.
6.
Press the "Back" button to change a setting or press "Save" to
conclude setup.
Switching the unit off
ü The unit has finished the machining operation.
➢ Press the On/Off button on the front.
Ä
The unit then switches off. The On/Off button changes from green
to blue.
5.5
Repacking
NOTE
Repack only drained units!
Drain the unit!
ü The water tank is empty.
ü The main switch on the back side of the unit is set to the
0
(OFF)
position.
1.
Disconnect the power cable and the connecting cable from the back
side of the unit and stow them away.
2.
Stow away the calibration tools in the drawer.
3.
Check the unit for completeness according to the scope of supply!
4.
Pack the unit securely.
5.6
Scope of supply
The detailed scope of supply is specified in the document "Checklist
CEREC Primemill".
5.7
Storage
NOTE
Repack only drained units!
Drain the unit! See "Removing water from the unit [→62]".
Store the unit in a closed and dry room at a temperature of -40°C
(-40°F) to 70°C (158°F).