Instructions Swift P1 Gimbals SIRIUS Website GUANGDONG SIRIUS OPTICAL Add: The Third Industrial District, Anguish Town, Tangshan City, Guangdong, China (Zip Code: 528458) Tel: 86-760-88897373 Fax: 86-760-88207062 E-mail: Website: www.sirui.
Know the SIRIUS Swift P1 A. LODE Screen B. USB Port C. Panning Balance Buckle D1. Rolling Balance Buckle E. Tilting/Panning Control Knob F. Shutter Button {connection to the camera is required) G. Focusing Button {connection to the camera is required) H. Mode Switch Button Camera is not included. J. Power Switch/Motor Force Switch K. Camera Regulating Knob L. Tilting Balance Buckle M. Wheel Dial N. Quick Release Plate O. Function Key 1 P. Function Key 2 Q. QR Plats Anti-slip Screw Lock R.
Included: 7 Li Swift P1 Gimbals x 1 Tripod x1 Bin | I.
1. Charge and Power on/off the Gimbals Before use, plug the USB cable provided into the mini USB port on the handle and the other end to a power source to charge for 2.5 to 3 hours. The charging status will be displayed on the LODE ul Press and hold the Power T7177] Witch 3 seconds to turn on/off the Gimbals. 2. Attach the camera to the Gimbals 24 iris recommended to power off the Gimbals before attaching or balancing the camera.
Balance the camera: EE Mote: The Gimbals will not function properly if the camera is not balanced. Install the lens support bracket: 5 Note: Stabilize the long camera lens with the mounting bracket.
3. Operation Wheel! Dial —— Shutter Button Focusing Button Nonparticipating Control Knob Mode Switch Button Power Switch/Motor Force Switch > To power up or off the Gimbals, press and hold the Power Switch for 3 seconds. {O Press the shutter button to control shooting when connected to the camera. { Press the focusing button to control focusing when connected to the camera. er as ere EAE 8.
Function Keys located on the back of the Gimbals handle: r Function Key 1 Function Key 2 Function Key 1: Press and hold down the upper Function Key 1 to activate the "Panning-Following” mode. Track the shooting objects actively as you pan the Gimbals and the phone quickly or proceed to move on to the next scene. Function Key 2: Press and hold down the lower Function Key 2 to switch between” Tilting-Following” and "Locked" modes. Press the Function Key 2 twice to reset all axes.
1. Please avoid placing the Gimbals into fire or near hot substances or liquid. 2. Please avoid dropping or striking the product which may damage the Gimbals. 3. Please charge the Gimbals with battery chargers in accordance with safety regulations. 4. Do not attempt to disassemble, repair or modify the Gimbals as this will void the warranty. 5. Do not clean the Gimbals with cleaning products as this may damages the product. 6.
Limitations: Warranty is non-transferals. This warranty covers all defects encountered in normal use of the equipment and does not apply in the following cases: the equipment has been serviced by other than an authorized SIRIUS Service Center. . Damage to the equipment caused by modification, overloading, mishandling, abuse, accident, sand”*, corrosives, water damage” or by not following recommended use as instructed. No valid proof of purchase is provided.
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.