User manual

If you don't want to synchronise the table call stations transmitter with the receiver using the
infrared sensor, you can also set the transmission frequency manually.
The keys for operating the device are accessible if you open the battery compartment on the
bottom side of the table call stations transmitter.
Use / to set the frequency.
ð
The display shows the set frequency. The setting is complete.
The key for operating the device is accessible if you open the battery compartment on the
bottom side of the table call stations transmitter.
1. Slide the switch on ‘H’ (high power) to use the transmitter from a long distance. This
mode reduces the battery runtime of the microphone.
2. Slide the switch on ‘L’ (low power) to use the transmitter from a short distance.
3. Hold the main switch pressed for several seconds to turn on the table call stations trans‐
mitter and to synchronise the transmitter with the receiver.
Setting the frequency manually
Setting the radio signal
Operating
38
Quad R 823, Quad H 823, Quad B 823, Quad C 823Quad R 470, Quad H 470, Quad B 470, Quad C 470
UHF Wireless System