User Manual

SISTEMATICA S.p.A. Pag. 4/4
Via S. Pertini, 17 – 12030 MANTA (CN) ITALY Tel. [phone] r.a. – Fax [phone]
http://www.sistematica.it e-mail: [e-mail]
PROBLEM IDENTIFICATION AND SOLUTION
P ROBLEM POSSIBLE CAUSES SOLUTIONS
Absence of power in the receiver
unit
-Check that the emergency mushroom button on the transmitter
(if present) is in the release position.
-Check that the vehicle batterie is correctly connected to the
receiver unit
-Check that the fuse inside the receiver unit is inctact, and if it is
not, replace it (see “FUSE REPLACEMENT”)
Incorrect connection of the
cabling to the utilities
-Check the cabling to indicators, electro-valves etc.
Incorrect installation of the
receiver
-The receiver must not be shielded by ferrous masses (see
“POSITIONING OF THE RECEIVER UNIT”)
Incorrect replacement of the
batteries
-Check that the batteries have been inserted correctly; if
necessary replace them (see “REPLACEMENT THE
BATTERIES” on the manual of the transmitter combined)
System not coded -Re-code the system (vedi “CODIFYING THE SYSTEM”)
Blown fuse
-Replacement of the fuse on the receiver board (see “FUSE
REPLACEMENT”)
The system does not
respond to the controls
Flat batteries
The GREEN led on the
remote control does not
light up when a key is
pressed
Flat batteries
Batteries almost flat
-Replacement of the transmitter batteries (vedi “REPLACEMENT
THE BATTERIES” on the manual of the transmitter combined)
Using the transmitter beyond its
maximum range
-Keep to a distance ≤ 120m from the receiver
The system responds to
the controls in a
discontinuous way
Connection to the battery and to
the utilities made with cables of
unsuitable section or lenght
-Chech that the connection to the battery and the utilities are
made with cables of suitable section and lenght
CE MARK
Declaration of conformity for Sistematica S.p.A. products can be required at: [e-mail]
This product may be subjected to usage restriction. Please contact [e-mail] for any further questions.
FCC STATEMENTS
These devices complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) these devices may not cause harmful interference and
(2) these devices must accept any interference received, including interference that may cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or tv interference caused by unauthorized modifications to these equipment.
Such modifications could void the user’s authority to operate the equipments.
SISTEMATICA S.p.A. Grantee Code: O8I
MULTIOUT 868 label example
FCC ID: O8IMULTIOUT12
- The external antenna option with the standard SMA connector is not offered in USA or Canada
- This option will only be offered after it is approved via a ClassII permissive change or reassessment application with the appropriate
regulatory authority.
______________________
Stefano Baudino