Operation Manual

• Connection control: Check "Connection control" to enable the
controlling of which wired can connect to this device. If a client is
denied to connect to this device, it means the client can't access
to the Internet either. Choose "allow" or "deny" to allow or deny
the clients, whose MAC addresses are not in the "Control table"
(please see below), to connect to this device.
4.5.3.1 Controltable
"Control table" is the table at the bottom of the "MAC Address Control"
page. Each row of this table indicates the MAC address and the expected
IP address mapping of a client. There are four columns in this table:
MAC Address MAC address indicates a specific client.
IP Address Expected IP address of the corresponding client. Keep it
empty if you don't care its IP address.
C When "Connection control" is checked, check "C" will
allow the corresponding client to connect to this device.
In this page, we provide the following Combobox and button to help you
to input the MAC address.
You can select a specific client in the “DHCP clients” Combobox, and
then click on the “Copy to” button to copy the MAC address of the client
you select to the ID selected in the “ID” Combobox.
Previous page and Next Page: To make this setup page simple and
clear, we have divided the “Control table” into several pages. You can
use these buttons to navigate to different pages.
4.5.4 Misc.