Operation Manual

you try to setup a wireless connection. You only need to press a button on

both wireless client and wireless router, and WPS will do the rest for you.

The wireless router supports two types of WPS: WPS via Push Button and

WPS via PIN code. If you want to use the Push Button, you have to push a

specific button on the wireless client or in the utility of the wireless client to

start the WPS mode, and switch the wireless router to WPS mode. You can

simply push the WPS button of the wireless router, or click the ‘Start to

Process’ button in the web configuration interface. If you want to use the PIN

code, you have to know the PIN code of the wireless client and switch it to

WPS mode, then fill-in the PIN code of the wireless client through the web

configuration interface of the wireless router.

WPS Check the box to enable WPS function and uncheck it to disable the

WPS function.

WPS Current Status If the wireless security (encryption) function of this

wireless router is properly set, you’ll see a ‘Configured’ message here.

Otherwise, you’ll see ‘UnConfigured’.

Self Pin Code This is the WPS PIN code of the wireless router. You may need

this information when connecting to other WPS-enabled wireless devices.

SSID This is the network broadcast name (SSID) of the router.

Authentication Mode It shows the active authentication mode for the

wireless connection.

Passphrase Key It shows the passphrase key that is randomly generated by

the wireless router during the WPS process. You may need this information

when using a device which doesn’t support WPS.