User's Manual

Table Of Contents

HM30 User Manual V1.2

binding with the ground unit.

Mark

If the HDMI monitor can display the FPV system’s starting image but not the video stream,

please observe the OSD information at top of the screen and check if it displays the signal

quality, then please refer to the Chapter 6.7 in this manual and follow it step by step.

The image display latency could be high or the video may freeze if the HM30 ground unit

is outputting video stream to multiple devices simultaneously.

Function Settings of the Ground Unit HDMI Output Converter

You can configure the below functions of the built-in FPV system for the HDMI

Output converter when it is connected with a mouse and an HDMI monitor at the

same time.

⚫ Change IP addresses for the video stream to switch to a different camera.

⚫ Switch the displayed unit of airspeed in the OSD information.

⚫ Enable or disable Mavlink OSD display.

⚫ Enable or disable longitude and latitude display.

⚫ Other functions.