Specification Sheet

Gold P31 SSD
July. 2020
SK HYNIX RESERVES THE RIGHT TO CHANGE PRODUCTS, INFORMATION AND SPECIFICATIONS WITHOUT NOTICE.
1) Measured using IOmeter1.1 with QD(queue depth) 32. Set to 128KiB alignment. (1MB/sec = 1,000,000 bytes/sec)
2) Measured using IOmeter1.1 with 4 threads, QD 32 each. Set to 4KiB alignment.
3) IOmeter1.1 is used for measuring. Measurements are performed on 1GB of LBA range with a queue depth 32 &
8 worker system. System variations may affect results. (Test Pre-condition : Secure erased and NTFS formatted of
a secondary drive)
4) Set to 128KiB alignment /1MB/sec = 1,000,000 bytes/sec was used in sequential performances.
5) Set to 4KiB alignment, 8 threads condition
6) Device measured by IOmeter1.1 with queue depth 1 workload and Read latency measured on random 4KiB transfers.
7) All numbers are average data measured out of more than 3 times
8) Active power is measured during execution of sequential write 128KB with queue depth 32.
9) Measured w/o condensation. And Operating mode is measured by temperature sensor, SMART Attributes Bytes 02:01h.
10) The SSD incorporate advanced technology for defect and error management, they use various combinations of hardware-
based error correction algorithms and firmware based static and dynamic wear-leveling algorithms.
11) 1.5M Mean Time Between Failures is estimated based on population. statistics not relevant to individual units through
12) Reliability demonstration Test (RDT).
13) Bit error rate will not exceed one sector in the specified number of bits read. In the unlikely event of a read error,
the SSD will report it as a read failure to the host; the sector in error is considered corrupt and is not returned to the host.