User's Manual

CDMA REPEATER
8. Maintenance Guide
8.1 Confirmation of System Components
For normal operation of equipment the following should be confirmed on installation.
A. Confirm whether the repeater’s exterior would be deformed by damaged package
of repeater on delivery.
B. Confirm that the components of equipment accord and that installation place
satisfies temperature and humidity for operation of equipment defined on the
product’s specification.
C. Confirm the input signal condition of equipment defined on the product’s
specification.
D. Confirm that the state of cable and connector is good.
E. Confirm that the state of bracket of repeater is good.
8.2 Cautions on System Installation
In order for dangerous events not to occur on installation of repeater, the provided guidance
should be followed.
Especially power codes are permanent connection typed so that easily accessible power switch
on/off device should be equipped at indoor service wires with outlets easily accessible to
repeater.
Orde
r
Description Cautions
1
Donor ANT welding and feeder
installation.
Service ANT or LCX equipped
• Cable should be installed without exterior damage.
• Protect connection parts like connector with insulation tape to
prevent humidity.
• Install feeder to minimize environment influence.
2 Installation of Antenna for Donor
• Strongly fixed for local wind velocity to prevent antenna’s
direction from bending after installation
3
Power cable and RF cable
arrangement
• Prevent cable from damaging by crooking or stretching.