User's Manual

And you need to d
AC/DC Adaptor)
If you have used
adapter to a PWR jack
PoE(Power-Over-
Ethernet) switch, you will not need the AC/DC
And then you can
connect the UTP cable to the ETH port
Lastly, you must
Wall-Mount-Bracket.
The
document chapter.
After all above pr
Wall-Mount-B
racket by the followings:
1.
Check the location of the
2.
Check the direction and location of the
3. Fit the
product
Wall-Mount-
Bracket
4.
Refer to the figure below.
SMR
18
And you need to d
etermine how power is supplied.
(PoE(Power
the AC/DC adapter, you should connect the enclosed AC/DC
adapter to a PWR jack
on the top of the SMR-AI231.
But if you use the
Ethernet) switch, you will not need the AC/DC
adapter.
connect the UTP cable to the ETH port
.
set the SMR-AI231
ID before you attach the
The
product
ID setting process is described in
After all above pr
ocesses are completed, you can attach the
racket by the followings:
Check the location of the
Wall-Mount-Bracket
Check the direction and location of the
Body-Mount-B
racket
product
to the Wall-Mount-B
racket while down from the top of the
Bracket
.
Refer to the figure below.
Figure 6. The SMR-AI231 Mounting
SMR
-AI231
(PoE(Power
-Over-Ethernet) or
the AC/DC adapter, you should connect the enclosed AC/DC
But if you use the
adapter.
ID before you attach the
product to a
ID setting process is described in
the supplement
ocesses are completed, you can attach the
SMR-AI231 to
racket
racket while down from the top of the
총무팀 / 사원 테스트용 / 10.1.10.134 / 2010- 02- 05 17:27 / 이 문서는 보안문서로서 외부 반출을 금합니다.
총무팀 / 사원 테스트용 / 10.1.10.134 / 2010- 02- 05 17:27 / 이 문서는 보안문서로서 외부 반출을 금합니다.