SK Telesys Mobile WiMAX Pico-BTS : User's Manual : Page 15

SMR-AI250

15

And you need to determine how power is supplied. (PoE(Power-Over-Ethernet) or

AC/DC Adaptor) If you have used the AC/DC adapter, you should connect the

enclosed AC/DC adapter to a PWR jack on the top of the SMR-AI250. But if you use

the PoE(Power-Over- Ethernet) switch, you will not need the AC/DC adapter.

And then you can connect the UTP cable to the ETH port.

Lastly, you must set the SMR-AI250 ID before you attach the product to a

Wall-Mount-Bracket. The product ID setting process is described in the supplement

document chapter. After all above processes are completed, you can attach the

SMR-AI250 to Wall-Mount-Bracket by the followings:

1. Indicate the position of drilling at the location of a wall-mount-bracket

installation. (ⓐ)

2. Make a hole in the wall using a drill. (ⓐ)

3. Clean the place and Push the screw anchor to its full depth in the hole.(ⓐ)

4. Fix the wall-mount-bracket in its position using an enclosed four 4Ø screws.

Insert the screw through the wall-mount-bracket being fastened and screw it

into the anchor tight. (ⓐ, ⓑ)

5. Check the location of the wall-mount-bracket.

6. Check the direction and location of the WiMAX Pico-BTS mount-bracket.

7. Fit the WiMAX Pico-BTS to the hole of wall-mount-bracket.

8. Turn the WiMAX Pico-BTS in a counter-clockwise direction until it clicks.

9. Refer to the figure below.

Figure 5. The SMR-AI250 Mounting

총무팀 / 사원 테스트용 / 10.1.10.134 / 2010- 01- 28 20:39 / 이 문서는 보안문서로서 외부 반출을 금합니다.