QuickTake 30 Owner's manual

Operation

Button Sequence

Bu ons must be pressed in the sequence

shown.

 or  = Press individually

[

] = Press both simultaneously

 = Security code, press in sequence

Operating the Pump

• To activate LED:

Press and hold

 for 2 seconds.

• To check battery status:

With the LED on, press

. If ba ery status is low, recharge the ba ery (see

Charging the Ba ery on page 6).

Battery Status Indicators

Full charge; approximately 75 to 100% ba ery capacity

remaining

Ba ery is charged enough to operate the pump;

approximately 25 to 75% ba ery capacity remaining.

Ba ery charge is low (charge ba ery); approximately

1 to 25% ba ery capacity remaining.

Low Ba ery Fault. Pump will stop running, beep, and

go to sleep in 10 seconds.