QuickTake 30 Owner's manual

Installing a Replacement Battery

1. With the back of the pump facing you (serial number

at bo om le ), use a small ﬂ at-head screwdriver

(tweaker) to pry up and remove two strip panels

from the le and right ends of the back of the case.

Removing the pressure-ﬁ t panels will reveal four

safety screws.

2. Use a Phillips head or ﬂ at-head screwdriver to

loosen the four safety screws.

3. Li oﬀ the back of the pump case.

4. Using a Phillips head

screwdriver, remove the

two screws and washers

from the ba ery bracket.

Set them aside.

Do not lose washer

from beneath each

screw.

5. Slide the bracket forward

and li it out of the

case.

6. Carefully li the

ba ery pack out of the

case and detach it from

the ba ery connector.

7. A ach the new ba ery to the connector.

8. Replace the ba ery pack in the pump case.

9. Slide the ba ery bracket in place and align the two screw holes. Reinstall the

two screws with washers.

10. Replace the back of the pump case (serial number label should be in the lower

le corner) and tighten the four safety screws.

11. Replace the two strip panels and press them down until completely installed.

Battery connector

pulls apart.

Battery

connector

Battery

cavity

Bracket

screws

Battery

Bracket

Slide bracket

forward and lift out.