User's Manual

INTEGRATION WITH SKF @PTITUDE OBSERVER
Enlight Collect IMx-1 System View
SKF Enlight Collect IMx-1 System
User Manual
Revision A
27 (84)
Edit, will launch the gateway properties dialog where extended status information can
be viewed.
If the gateway status deviates from OK, this will also be reflected by appropriate
system or critical system alarms being raised.
Configuration:
• Not synchronized: the configuration held by @ptitude Monitor/Observer is
different to that in the gateway. This will not be corrected until/unless the user
initiates a synchronise action.
• Staged: a synchronise action has been initiated.
• Pending: Monitor has received the synchronisation request and is due to
send the configuration to the gateway.
• Notified: the gateway has received the new configuration.
• Synchronized: the configuration in @ptitude Monitor/Observer and in the
gateway are verified as being the same.
Connection:
• Connected
• Closed
Hardware ID: The unique identifier of the gateway. If the gateway is commissioned
and has successfully connected to @ptitude Observer, it will show a MAC address in
this field.
Sensors: The number of sensors linked to the gateway.
Sensors needs attention: The number of sensors with errors, needing attention.
IP Address: The IP address that is used by the gateway.
Firmware Version: The version of firmware, installed in the gateway.
Location: Descriptive text for the physical location.
2.3.2 Sensors
Similarly, for sensors the following properties are shown in the sensor table:
Name: Name given to the sensor.
Self diagnostics status: Displays the latest reported self-diagnostic status or in
case of multiple errors the item considered most critical. The status field will initially
be empty until the actual sensor status has been received.
• "Ok" or an error of any of the following types. Values in brackets are decimal
values corresponding to the bit set in the mesh network information log, Self-
Diagnostic entry, when the error is true:
o Battery level low (1)