User's Manual

INSTALLATION AND COMMISSIONING
SKF Enlight Collect gateway
SKF Enlight Collect IMx-1 System
User Manual
Revision A
43 (84)
When using fibre optics or PoE, suitable network hardware must be in place.
3.2.3.2 Wi-Fi
The built-in Wi-Fi module provides an alternative network connection method where
a wireless network is available. The gateway provides an integral radio antenna, no
connection to an external antenna is required.
3.2.3.3 TCP and UDP port usage
The following table lists the port usage for the various types of external connection
the gateway needs to establish, ensure that legitimate traffic through these ports is
not being blocked by a firewall.
Table 3 TCP and UDP Port Usage
Port
Type
Comment
1883
TCP
MQTT broker
123
UDP
NTP (Network Time Protocol) server.
53
UDP/TCP
DNS (Domain Name Server) – usually UDP.
3.2.3.4 LTE/UMTS mobile data
Whilst the gateway does not currently support an integrated mobile data connection
an external 3G/4G modem could still be used.
3.2.4 Commissioning
The Enlight Collect Manager app guides the user through the related processes of
gateway commissioning and decommissioning. Gateway commissioning requires a
gateway in a non-commissioned state and the app running on a mobile device with
an active Bluetooth interface. The pre-requisite configuration work in @ptitude
Observer software must also have been completed, refer to sections 2.1 through 2.4.
A. Launch the app. Note an earlier log in with network access is recommended.
B. Select ‘Scan Gateway’ function, from the Main menu.
With the gateway powered and in place the user can choose, in-app, to scan for and
then identify the gateway via either:
• ‘QR’ (Quick Response) code
• ‘Bluetooth’, the user chooses from a list of gateways that are in range
Note: If due to its physical location it is not possible to reach the gateway to uniquely
identify it and the ‘Bluetooth’ method is used, be aware that multiple gateways may
be detected by a scan and take care to identify the correct device.
C. Select the gateway in order to connect to it and view its status.