User's Manual

PRODUCT DESCRIPTION
SKF Enlight Collect gateway
12 (92)
SKF Enlight Collect IMx-1 System
User Manual
Revision C
yet implemented do not enclose the gateway inside a further/outer enclosure that
would block the radio signals.
Note: gateways must be associated with their own set of sensors, a particular sensor
can only communicate with one gateway.
1.3.1 Connections and interfaces
The gateway is housed in an IP rated enclosure suitable for indoor or outdoor
installation and has built-in antenna for Wi-Fi and sensor mesh communications. The
lower panel is the only area normally accessible to the user and conceals connectors
for all wired connections. A view of the gateway with its various features and
connections highlighted, is shown below:
Figure 2 View on gateway and mounting plate with key features annotated
To access the connector area, unscrew the two Torx T10 screws on the lower edge
of the cover at the locations circled in the image above. Once this cover is removed,
four M12 connectors and one blanking plug are accessible:
1. Connector for dual speed inputs with transducer power (future use)
2. Connector for Ethernet link 2 (future use)
3. Connector for Ethernet link 1 and PoE
4. Connector for DC power input to the gateway
5. Access to SIM card holder (future use)