User's Manual

INTEGRATION WITH SKF @PTITUDE OBSERVER
Hierarchy view – adding sensors and measurements
SKF Enlight Collect IMx-1 System
User Manual
Revision C
23 (92)
this option is chosen measurement data and any alarm thresholds are automatically
adjusted in interactions with the sensor.
Being global settings, these apply to all IMx-1 sensors in the database and also to
the units used for the gateway, internal temperature measurement. Pressing the
default settings button, on the lower left edge of the dialog, selects the choices in
bold above.
2.2 Hierarchy view – adding sensors and measurements
IMx-1 sensors are added to sub-machines in the @ptitude Observer Hierarchy. Right
click on the appropriate asset node and select "Enlight Collect IMx-1 Sensor" from
the "Add" sub-menu:
Figure 9 Add – IMx-1 Sensor
When added to the hierarchy a node for the IMx-1 sensor is created along with a four
point ‘cluster’ of Temperature, Acceleration, Velocity and Envelope measurements,
refer the figure below.
Figure 10 Hierarchy: IMx-1 sensor example
As shown above, the automatic measurement point naming takes the user chosen
sensor name, adds a dash/hyphen and then 1 or 2 characters to identify the
measurement type. Measurement naming is automatically updated if the sensor
name is subsequently changed.
Most @ptitude Observer hierarchical status indications, like Not measured, are
supported or applicable to an IMx-1 sensor and measurements except the following: