User's Manual

INTEGRATION WITH SKF @PTITUDE OBSERVER
Enlight Collect IMx-1 System View
28 (92)
SKF Enlight Collect IMx-1 System
User Manual
Revision C
The status field will initially be empty until the actual gateway status has been
received. Note that double clicking a gateway entry or selecting it and then choosing
Edit, will launch the gateway properties dialog where extended status information
can be viewed on the Gateway status tab.
If the gateway status deviates from OK, this will also be reflected by appropriate
system or critical system alarms being raised.
Synchronized:
• No: the configuration held by @ptitude Monitor/Observer is different to that in
the gateway.
• In progress: a synchronise action is under way.
• Yes: the configuration in @ptitude Monitor/Observer and in the gateway are
verified as being the same.
Connection:
• Connected
• Closed
Hardware ID: The unique identifier of the gateway. If the gateway is commissioned
and has successfully connected to @ptitude Observer, it will show a MAC address in
this field.
Sensors: The number of sensors linked to the gateway.
IP Address: The IP address that is used by the gateway.
Firmware Version: The version of firmware, installed in the gateway.
Location: Descriptive text for the physical location.
2.3.2 Sensors
Similarly, for sensors the following properties are shown in the sensor table:
Name: Name given to the sensor.
Self diagnostics status: Displays the latest reported self-diagnostic status or in
case of multiple errors the item considered most critical. The status field will initially
be empty until the actual sensor status has been received.
• "Ok" or an error of any of the following types. Values in brackets are decimal
values corresponding to the bit set in the mesh network information log, Self-
Diagnostic entry, when the error is true:
o Battery level low (1)
o External Flash memory failure (16)
o Configuration CRC failure (64)
o Firmware update error (128)