User's Manual

INTEGRATION WITH SKF @PTITUDE OBSERVER
Use of @ptitude Observer machine templates
38 (92)
SKF Enlight Collect IMx-1 System
User Manual
Revision C
Figure 25 Hardware ID clear button – Relay mode sensor example
Clearing a Hardware ID does not remove measurement data but allows another
physical device to be commissioned as a replacement for the previous one.
Note that similarly, if just moving a sensor from one monitoring location to another
(decommission it and then recommission it in a new position), until the sensor’s
Hardware ID is cleared from the first location, it will be unable to connect in its new
position due to the system having two sensors with the same Hardware ID. In this
condition the gateway will report its Self diagnostic status as ‘Missing/Invalid
Configuration’ until the duplication is corrected by clearing the sensor Hardware ID
from the ‘old’ location.
2.5 Use of @ptitude Observer machine templates
When creating a new machine, @ptitude Observer supports the use of machine
templates, where the template to be used is selectable from a drop-down list. These
templates are complete with all machine and measurement point properties.
As IMx-1 measurements are somewhat different to those performed by other IMx
devices it is important to be able to easily distinguish ‘IMx-1’ templates. To achieve
this, it is recommended that users adopt the following naming taxonomy for all
machine templates:
DAD_Asset Class_Asset Type_Manufacturer Name_Manufacturer Model
Example IMx1_Turbine_Wind_Company_V99
• DAD (Data Acquisition Device): IMx1
• Asset Class: Turbine
• Asset Type: Wind
• Manufacturer Name: Company
• Manufacturer Model: V99