User's Manual

INSTALLATION AND COMMISSIONING
SKF Enlight Collect gateway
46 (92)
SKF Enlight Collect IMx-1 System
User Manual
Revision C
Note: If due to its physical location it is not possible to reach the gateway to uniquely
identify it and the ‘Bluetooth’ method is used, be aware that multiple gateways may
be detected by a scan and take care to identify the correct device.
C. Select the gateway in order to connect to it and view its status.
D. The gateway should be decommissioned, press Commission to proceed.
E. Now choose the ‘virtual’ gateway, configured in @ptitude Observer, that this
physical gateway should be associated with. Virtual gateways will be listed
with both their name and location text visible. Virtual gateway locations that
are already commissioned will have MAC addresses associated with them
and be unavailable for selection.
F. Having now selected the associated physical and virtual gateways press
Commission to complete the process.
The configuration the gateway now has is not the measurement configuration but the
settings that facilitate data exchange with its sensors and the @ptitude Observer
software. The latter includes:
• The gateway networking interface:
o Ethernet (wired)
o WiFi
• IP configuration for the selected network interface
o DHCP or
o Static: IP address, subnet mask, gateway and DNS settings
• Wi-Fi connection setup, where Wi-Fi selected
o Security: WPA2-Personal or WPA2-Enterprise
o SSID and password: password received and stored by the gateway
as an encrypted string
o Country
o CA (Certificate Authority) certificate, EAP (Extensible Authentication
Protocol), Identity and similar configuration data where
WPA2-Enterprise security is in use.
• Sensor, mesh radio setup
o Security: 128-bit AES encryption key
o A unique, mesh network, identifier
• Configuration for the software connection
o @ptitude Observer Monitor connection address
o Client certificate (if TLS is being used)