User's Manual
Manuals
Brands
Skidata Manuals
Electronics
Inductive Tag Reader for Turnstile
11
12
13
14
15
16
17
18
19
20
Table Of Contents
Cover
01 - Main table of Contents
Main Table of Contents
Main Table of Contents
02 - Introduction, Safety Requirements, EMV
Introduction, Safety Requirements, Electromagnetic Compatibility (EMC)
Contents
Typographical Conventions and Notation
Text
Symbols
Safety Instructions
General Safety Instructions and Warnings
Notes concerning wearers of medical devices and implants
Danger of injury by rotating parts
Safety Instructions – Turnstile DKZ x70 i
Operating Hazards of Turnstile x70 i
Safety Precautions during Maintenance
Obligation of the operator to meet safety requirements
Safety and Warning Devices
Training of Operating Personnel
Appropriate Use
Warranty and Liability
Electromagnetic Compatibility (EMC)
ESD Protection guidelines
03 - Maintenance
Maintenance
Contents
Opening the Reader
Reader cable connections
Maintenance
Required Tools
Cleaning the barcode scanner
General
Cleaning the glass cover panes (Reader AS x70i Cx/V2)
Replacing the LEDs of the status indicator light
Adjusting the ticket stopper
Detaching the ventilator
Cleaning the ventilator
Replacing the ISO 15693 transceiver (BLL) module
Installing a Legic module
Retro-fitting an ISO 14443 "Feig" module
Maintenance
6
Opening
the Reader
3.2
© SKIDATA AG, Version 1.0
Page 3
3.2
Opening the Reader
Unfasten the two fastening screw
s (M5x20, use No. 4 Allen
wrench) on the rear of the reader.
Pull out the front panel as far as it will go
Fig. 1
Reader AS x70i Cx/V2:
Fastening screws
1
...
...
17
18
19
20
21
...
...
38
