Use and Care Manual

12.
Assembling the Stand
1. Slide the legs 1 into the stand (Fig. 5).
2. Align the hole in the leg with the hole in the stand.
3. Install a bolt 2 through each leg.
4. Use a wrench and a phillips screwdriver and tighten the nuts
3 securely.
Mounting Saw to Stand
1. With the help of an assistant, lift the saw and slide the tabs
1 on the back of the saw into the slots 2 on the stand
(Fig. 6).
2. Hook the wire from the clamp 3 located at the front of stand
over the tab 4 on the saw base (Fig. 7).
3. Press the clamp down to lock the saw to the stand.
4. Repeat the procedure for the other clamp.
To reduce the risk of personal injury, do not
operate table saw with stand until you have read
and understand the following:
• Do not stand on the table saw stand or use as a ladder or
scaffolding.
• Do not open or close stand with table saw mounted.
• Do not use table saw if stand tips, slides or moves in any
way.
• Before operating table saw, ensure table is securely
fastened to stand and entire unit must be placed on solid,
level surface.
Assembly
1
2
3
FIG. 5
2
1
FIG. 6
4
3
FIG. 7
WARNING
!
SM 2610028628 01-13 E_SM 2610028628 01-13 E.qxp 1/11/13 2:46 PM Page 12