Use and Care Guide
-8-
# !
!
To prevent personal injury,
always disconnect the plug
from the power source before removing or
installing the belt.
,,7 @6<9-05.,9:(5+*36;/05.(>(@-964
;/,),3; They could get cut or wedged
between the pulley, belt and motor housing.
!#!
1. Place sander on it’s side and move lever in
direction of arrow to retract front pulley and
release belt tension (Fig. 2).
2. With the sander on it’s side and the open
side facing you, you can easily remove the belt.
! !!
1. While the sander is still on it’s side with the
front pulley retracted and locked, insert the new
belt around both pulleys and over the metal
plate. If belt has directional marks, be sure the
arrow on the inside of belt is pointing in the
direction of rotation as indicated on housing.
2. Then push lever back to its original position
to return tension to the belt.
::,4)3@
!
WARNING
FR
O
N
T
PU
LLEY
REAR PULLEY
BELT TENSION
RELEASE LEVER
DIRECTION OF
TRAVEL
METAL
PLATE
!" ! !
The integral dust extraction system collects
sanding dust in canister supplied with your
sander. For maximum efficiency, the dust
canister should be emptied frequently during
operation.
&6<9;6630:,8<077,+>0;/(
+<:; *(50:;,9 ,47;@ 0;
-9,8<,5;3@(-;,9*6473,;0656-:(5+05.(5+
),-69,:;6905. ;/, :(5+,9 Be extremely
careful of dust disposal, materials in fine
particle form may be explosive. Do not throw
sanding dust on an open fire. Combustion
from mixture of varnishes, lacquers,
polyurethane, oil or water with dust particles
can occur if there is a static discharge, spark
introduced in the box, or excessive heat.
# !" !
!
To remove dust canister, simply pull away
from the tool (Fig. 3).
To install dust canister, align dust port tab
with slot in canister and push canister onto
tool.
!&
!" ! !
Remove canister from tool and knock excess
dust out of the microfilter, or remove dust
with your fingers or a soft brush. You may
notice that all the dust may not come out of
the canister. This will not affect sanding
performance but will reduce dust collection
efficiency.
NOTE: Do not wash the micro filter with soap
and water. Dust may become more firmly
lodged in the pores, which will reduce dust
collection, and damage the micro filter.
FIG. 2
!
WARNING
SM 2610019941 08-11:SM 2610019941 08-11.qxp 8/15/11 9:07 AM Page 8