Use and Care Manual
13
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of re, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack or charger in
uid or allow a uid to ow inside them.
Corrosive or conductive uids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc, can cause a short
circuit.
WARNING
If any parts are damaged or missing, do not operate this product until
the parts are replaced.
Use of this product with damaged or missing parts
could result in serious personal injury.
WARNING
Do not attempt to modify this tool or create accessories not
recommended for use with this tool.
Any such alteration or modication
is misuse and could result in a hazardous condition leading to possibly serious injury.
WARNING
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
parts, making adjustments, or cleaning the tool.
This cordless angle grinder must be used only with the battery packs and charger listed below:
Battery Pack
Charger
2Ah 2Ah 2.5Ah 4Ah 5Ah
SKIL
BY519701
SKIL
BY519702
SKIL
BY519703
SKIL
BY519601
SKIL
BY519603
SKIL
SC535801
SKIL
QC536001
NOTICE:
Please refer to the battery pack and charger manuals for detailed operating
information.
Wheel Guard Installation (Fig. 2, 3)
WARNING
Use the wheel guard with disc grinding wheels. Always close the
guard release/lock latch to secure the guard. Keep the guard between
you and the wheel. Do not direct the guard opening toward your body.
Turn the tool OFF and remove the battery pack before performing any assembly.
To install the wheel guard:
a. Remove the battery pack from the tool.
b. Open the guard release/lock latch and position the wheel guard on the spindle neck so that
the two bumps on the guard align with the two notches on the spindle neck.
c. Rotate the wheel guard to the desired position, then close the guard release/lock latch to
secure the guard in place.
Fig. 2