Use and Care Manual

Removable Belt Clip

Your tool is equipped with a removable belt clip

that can be positioned on the left side of the

tool for convenient transport (Fig. 9).

Install the belt clip onto the tool:

a. Remove the battery pack from the tool.

b. Align the rib of the belt clip with the threaded

hole on the base of the tool.

c. Insert the screw and securely tighten the

screw with a screwdriver.

Remove the belt clip from the tool:

d. Remove the battery pack from the tool.

e. Use a screwdriver to loosen the screw that

attaches the belt clip to the tool.

f. Remove the screw and the belt clip.

Drill Bits

Always inspect drill bits for excessive wear. Use only bits that are sharp and in good condition.

Twist Bits: Available with straight and reduced shanks for wood and light-duty metal drilling.

High-speed bits cut faster and last longer on hard materials.

Drilling (Fig.10)

WARNING

Always wear safety

goggles or safety glasses

with side shields during power tool

operation or when blowing dust. If the

operation is dusty, also wear a dust mask.

a. Check that the direction-of-rotation selector

is at the correct setting (forward or reverse).

b. Secure the material to be drilled in a vise or

with clamps to keep it from turning as the

drill bit rotates.

c. Hold the drill rmly and place the bit at the

point to be drilled.

d. Squeeze the trigger switch to start the drill

driver.

e. Move the drill driver bit into the workpiece, applying only enough pressure to keep the bit

“biting”. Do not force the drill driver or apply side pressure to elongate a hole. Let the tool

do the work.

f. When drilling hard, smooth surfaces, rst use a center punch to mark the desired location of

the hole. This will prevent the drill bit from slipping off-center as the hole is started.

g. When drilling metals, use light oil on the drill bit to keep it from overheating. The oil will

prolong the life of the bit and increase the drilling action.

Fig. 10

Fig. 9