Owner's Manual

18
Line Replacement
NOTICE:
Always use the recommended
nylon cutting line with a diameter that does
not exceed 0.080 in. (2.0 mm). Using line
other than that specied may cause the string
trimmer to overheat or become damaged.
WARNING
Never use metal-
reinforced line, wire, or
rope, etc. These can break off and become
dangerous projectiles.
WARNING
To prevent serious
personal injury, remove
the battery pack from the tool before
servicing, cleaning, changing attachments
or removing material from the unit.
1. Remove the battery pack from the trimmer.
2. Cut one piece of cutting line 16 ft. (5m)
long. Insert the line into the eyelet. Push
the line until the end of the line comes
out of the other side of the trimmer head.
Pull the line from the other side until equal
amounts of line appear on both sides
(Fig. 15).
3. Press, while rotating the spool retainer in
the direction indicated by the arrow to wind
the cutting line into the spool is inside the
trimmer head until approximately 5.1 in.
(13cm) of line is showing on each side
(Fig. 16).
4. Push down on the trimmer head while
pulling on the lines to manually advance the line and to check for proper installation of the
cutting line.
Fig. 15
Arrow
Direction
Eyelet
Fig. 16
5.1’’ (13cm)