Use and Care Guide

13
3. Refer to Fig.7: press the front-assist handle
onto the shaft and assemble the hex bolt
with the wing nut. Turn the front-assist
handle upward so that it points toward the
top of the rear handle.
4. Adjust the front-assist handle position so
that it is between the rear handle housing
and the hinge of the shaft, as shown in
Fig. 8. The handle should be adjusted so
that your front arm will be straight when
using the trimmer.
5. Tighten the wing nut so that the handle
cannot be rotated on the shaft.
Fig. 7
Fig. 8