Use and Care Manual

"! 
Disconnect plug from power source. The foot
can be adjusted up to 45° by loosening the
bevel adjustment lever at the front of the saw.
Align to desired angle on the graduated
quadrant. To adjust beyond 45°, depress 45°
stop spring (Fig. 6), align foot to desired mark
over 45° on quadrant and tighten lever.
+)';9+ 5,:.+/4)8+'9+*
'35;4: 5, (2'*+
+4-'-+3+4:/4 :.+=581 '4**+)8+'9+*
9:'(/2/:? 5, :.+,55: (2'*+(/4*/4- 3'?
5));8 ++6 :.+ 9'= 9:+'*? '4* :.+ ,55:
,/832?54:.+=5816/+)+
-10-
Disconnect plug from power source. Loosen
the depth adjustment lever located between
the guard and handle of saw. Hold the foot
down with one hand and raise or lower saw by
the handle. Tighten lever at the depth setting
desired. Check desired depth (Fig. 3).
Not more than one tooth length of the blade
should extend below the material to be cut, for
minimum splintering (Fig. 4).
A! 
Disconnect plug from power source. Set foot to
maximum depth of cut setting. Loosen bevel
adjustment lever, set to 0° on graduated
quadrant, retighten lever and check for 90°
angle between the blade and bottom plane of
foot with a square. Make adjustments by turning
the small adjustment screw from the bottom
side of foot, if necessary (Fig 5).
 ! 
6+8':/4-49:8;):/549
FIG. 3
FIG. 4
FIG. 5
FIG. 6
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
DEPTH
ADJUSTMENT
LEVER
DEPTH SCALE
Calibrated For
Standard Lumber
Sizes
BLADE WRENCH
& STORAGE
AREA
BEVEL
ADJUSTMENT
LEVER
BEVEL
ADJUSTMENT
LEVER
GRADUATED
QUADRANT
BLADE
90°
FOOT
45°
SPRING
STOP
GRADUATED
QUADRANT
!
WARNING
ALIGNMENT
SCREW
SM 1619X08870_SPT67W 7/24/14 2:21 PM Page 10