Operation Manual

Sound settings
The scope of the following menu is dependent on the vehicle equipment with
the sound system.
›
Press the

button, then tap on the function surface

surface.
■
Volume - Volume settings
■
Announcements - Adjustment of traffic announcements volume (TP)
■
Navigation announcements - sets the volume for the navigation announce-
ments
■
Voice control - volume setting for voice output
■
Maximum switch-on volume - Sets the maximum volume after switching on the
device
■
Speed-dependent vol. adjustment - increases the volume as speed increases
■
AUX volume: - Sets the volume for the device connected via AUX
■
Quiet - low volume
■
Medium - Medium volume
■
Loud - High volume
■
Bluetooth audio: - Volume setting of the device connected via Bluetooth
®
au-
dio profile of the connected external device
■
Entertainment fading while parking - Lowers the audio volume (e.g. radio volume)
with activated parking aid
■
Entertainment fading (nav. announcements) - Lowers the audio volume (e.g. radio
volume) in the event of a nav. announcements
■
Bass - Mid - Treble - setting the equalizer
■
Balance - Fader - Sets the balance between left and right, front and rear
■
Subwoofer - Subwoofer volume settings
■
ŠKODA Surround - Turn surround sound on/off (Cannot be used in Radio mode)
■
Virtual Subwoofer -Turn virtual subwoofer on/off (Cannot be used in Radio
mode)
■
Sound Character - Select the sound character (applies to Yeti)
■
Surround - Optimising the sound for the room (applies to Yeti)
■
Sound focus -Setting the optimum room sound perception
■
All - Optimising the sound for the entire vehicle interior
■
Driver - Optimising the sound for the driver
■
Touchscreen tone - Switch on/off audible tone when touching the screen
■
No navigation announcements during call - Switches on or off the navigation
prompts during a telephone conversation
Screen settings
›
Press the

button, then tap on the function surface

Tap→ screen .
■
Switch off screen (in 10 seconds) - Enable / disable the automatic power off func-
tion
■
Brightness: - Adjusts the brightness of the screen
■
Touchscreen tone - Switch on/off audible tone when touching the screen
■
Proximity sensor - Turn the proximity sensors on/off (When the function is on,
e.g.Navigation will be shown in the main menu when moving a finger to-
wards the bottom bar with the functional surfaces on the screen)
■
Show clock in standby mode - Time and date displayed on the screen when the
ignition is switched on and the unit is switched off
Time and date settings
›
Press the

button, then tap on the function surface

Tap on → Time and
date .
■
Clock time source: - Setting the time source: manual / GPS (applies to Amund-
sen)
■
Time: - Time settings
■
Summer (DST) - Switches the summer time setting on/off (applies to Amund-
sen)
■
automatically adjust DST - Turn on / off the automatic switch to daylight saving
time
■
Time zone: - Select the time zone
■
Time format: - Set the time format
■
Date: - Date settings
■
Date format: - Set the date format
Note
With the Yeti model, the time and date settings are set via the MAXI DOT dis-
play» Owner's Manual.
Setting the device language
›
Press the

button, then tap on the function surface

Tap on → Language .
›
Select the device language or tap the function surface Automatic to set the
MAXI DOT display matching language (applies to the Yeti).
In some languages, after selecting the function surface Female and Male are dis-
played for the choice of voice prompts for the device.

16
Device operation and settings