Operation Manual

AUX and USB inputs
Fig. 104
Installation locations of the AUX
and USB inputs
Read and observe on page 89 first.
The AUX input is above the storage compartment in the front centre console
and is identified with the

mark » Fig. 104.
The MDI input is above the storage compartment in the front centre console
and is identified by the symbol

.
Additional information» Owner´s Manual Infotainment.
Multimedia holder

Introduction
This chapter contains information on the following subjects:
Install/remove
99
Handle holder
100
External devices (e.g. tablet, smartphone, etc.) measuring min. 122 mm and
max. 195 mm can be secured in the support.
The maximum permissible load of the holder is 750 g.
CAUTION
Never exceed the maximum permissible load of the holder - there is a risk of
damage or functional impairment.

Install/remove
Fig. 105 Position adapter/install holder
Fig. 106 Remove holder/remove adapter
Read and observe on page 99 first.
Fitting
›
Attach the opened adapter to the guide rods of the headrest
» Fig. 105.
›
Clip in the adapter in the direction of arrow
1
» .
›
Clip the holder in the direction of arrow
2
into the adapter.
Removing
›
Pull on the locking strap
A
in the direction of arrow
3
» Fig. 106.
›
Remove the holder from the bracket in the direction of arrow
4
.
›
Press the adapter and remove from the guide rods of the headrest in the di-
rection of arrow
5
.
WARNING
Carefully clip in the adapter - there is a risk of injuring your finger.

99
Transporting and practical equipment