Operation Manual

Replacing the rear window wiper blade
Fig. 237 Rear window wiper blade
Read and observe
on page 225 first.
Removing the wiper blade
›
Lift the wiper arm from the window in the direction of
1
» Fig. 237.
›
Tilt the wiper blade to the stop in the same direction.
›
Hold the upper part of the wiper arm and press the securing mechanism
A
in the direction of arrow
2
.
›
Remove the wiper blade in the direction of the arrow
3
.
Attaching the windscreen wiper blade
›
Push the windscreen wiper blade to the stop until it locks into place.
›
Check that the windscreen wiper blade is correctly attached.
›
Fold the windscreen wiper arm back to the windscreen.

Fuses and light bulbs
Fuses

Introduction
This chapter contains information on the following subjects:
Fuses in the dash panel – LHD 227
Fuses in the dash panel – RHD 227
Assignment of the fuses in the dash panel 228
Fuses in the engine compartment 229
Assignment of fuses in the engine compartment 229
Individual electrical circuits are protected by fuses.
Switch off the ignition and the corresponding power consuming device before
replacing a fuse.
Find out which fuse belongs to the component that is not operating
» page 228, Assignment of the fuses in the dash panel or » page 229, Assign-
ment of fuses in the engine compartment.
Electrically adjustable seats are protected by automatic circuit breakers, which
switch on again automatically after a few seconds after the overload has been
eliminated.
Colour coding of fuses
Fuse colour Maximum amperage
light brown 5
dark brown 7.5
red 10
blue 15
yellow/blue 20
white 25
green/pink 30
orange/green 40
red 50

226
Do-it-yourself