User's Manual Part 2


8JadeOSUserManual
Step4 Entertheglobalmodeusingthefollowingcommand:
(JadeOS) > enable
Password: enable
Whenyouareinenablemode,the>promptchangestoapoundsign(#):
(JadeOS) #
Step5 Entertheconfigur ationmodeusingthefollowingcommand:
(JadeOS) # configure terminal
Whenyouareintheconfigurationmode,‘config’appearsbeforethe#prompt:
(JadeOS) (config) #
3.1.2CLIAccessviaaRemoteConsole
UserscanaccessJadeOSremotelyusingTELNETfromaTCP/IPnetwork.
ToaccessJadeOSviatelnetyouneedtoenabletelnetsessionsusingtelnetclicom‐
mand.
ToconnecttotheCLIusingTELNET,completethefollowingsteps:
Step1VerifythatyourterminalemulationprogramorDOSshellinterface (for
example:SecureCRT)isconfiguredasshowninfigure3‐2:

Figure3‐2Telnetconnectionsettings
Step2Enteravalidusernameandpasswordasprompt.
3.2CLIFeatures
Thischapterwillgiveagener alintroductionabouttheCLIcommands.