User's Manual


64JadeOSUserManual
is RP
(JadeOS) (AAA profile "AAA")#authentication-radius-proxy RP
Step 3 Specify the aaa profile in config mode
(JadeOS) (AAA profile "AAA")#aaa radius-proxy aaa profile AAA
Step 4 Enable Radius proxy in config mode
(JadeOS) (AAA profile "AAA")#aaa radius-proxy enable
9.8.2 Configuring EAP-SIM
EAP-SIM is one of the EAP authentication protocol based on 2G SIM card through
which users access to WLAN network.
Differed from other authentication protocol, EAM-SIM takes use of the user data and
original authentication message be stored in SIM card to authenticate user and gener-
ate session key to access WLAN. At the same time the data will be stored in the ISP’s
HLR to avoid the authentication message transfer on Internet to prevent user data
from network attack.
EAP-SIM is the authentication protocol applied in 2G networks and EAP-AKA is ap-
plied in 3G network. EAP-SIM authentication is performed when users use SIM card
and EAP-AKA authentication is performed when users use USIM card. EAP-SIM and
EAP-AKA is specified in RFC 4186 and RFC 4187 respectively.
Figure 9-1 EAP-SIM authentication
To configure EAP-SIM authentication on JadeOS, following the steps:
Step 1 Configure Radius Server and Server Group
(JadeOS) (config) # aaa authentication-server radius r1
(JadeOS) (RADIUS Server "r1") #host 1.1.1.1
(JadeOS) (RADIUS Server "r1") #key 123