ShrapnelQuick Guide Quick Start, would like to show visually for first page: Power On Power Off Pairing Battery Life
Shrapnel User Guide ‐Technical Draft Main Speaker Controls Power On Long press and hold the Power Button. Wait (for up to 3 seconds) for the LED lightto flash magentaand the power on tone to be played. Do not press any other buttons during this time. When Shrapnel is on, the speaker will look to connect to up to 2 devices in the paired device list. If no paired devices are available for connection, the speaker will enter a NOT connected state and the LED will flashred2x every 3 seconds.
Music Controls Start Music Playback When the speaker is connected to the device but not streaming music, short press the roundMFBto start streaming. When the device is streaming, the frontLED will be off. Pause Music Playback When the speaker is streaming music, short press the round MFBto pause the playback. Volume Up When the speaker is ON and not in pairing mode, short press the + button to increase the volume level.
Mute Mic function When the call is active, short press the power button to mute the microphone, and again short press the power button to unmute. Volume function Short press the volume + to increase call volume, and short press the volume – to decrease the call volume. 2nd Incoming call While the active call is connected, short press the round MFB to end the current call and answer the 2nd incoming call.
‐ If restoring defaults does not solve the problem, remove Shrapnel from Device: Go in to pairing settings on the device and remove or ‘forget’ Shrapnel and then pair again. Wired audio will not play… If wired audio will not play, make sure that no device is streaming to the speaker. Disconnect paired devices from the speaker.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
