Users Manual
FCC Statement
This
device
complies
with
part
15
of
the
FCC
rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
thi
s
device
may
not
cause
harmful
interference,
and
(2)
this
device
must
accept
any
interference
received,
incl
uding
interference
that
may
cause
undesired
operation.
Changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user’
s
authority
to
operate
the
equipment.
NOTE:
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digital
device,
pursua
nt
to
part
15
of
the
FCC
Rules.
These
limits
are
designed
to
provide
reasonable
protection
against
harmful
inte
rference
in
a
residential
installation.
This
equipment
generates
uses
and
can
radiate
radio
frequency
energy
a
nd,
if
not
installed
and
used
in
accordance
with
the
instructions,
may
cause
harmful
interference
to
radio
com
munications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turn
ing
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the
following
measures:
‐
Reorient
or
relocate
the
receiving
antenna.
‐
Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐Consult
the
dealer
or
an
experienced
radio/TV
technician
for
help
important
announcement
Important Note:
In
the
event
that
these
conditions
cannot
be
met
(for
example
certain
laptop
configurations
or
co-location
with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID cannot be
used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the
end product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
The
final
end
product
must
be
labeled
in
a
visible
area
with
the
following"
Contains
FCC
ID:
2ADDD-FFV580P02A"
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module.
The end
user manual shall include all required regulatory information/warning as show in this manual.