Users Manual

Factory Reset
Caution: If you initiate a Factory Reset, the Doorbell Camera will
need to be re-connected to Wi-Fi and resynced with the account.
Press and HOLD the button until the LED begins a Yellow rapid
strobe flash. The reset could take up to 2 minutes.
Online Resources
Visit alarm.com/doorbell for troubleshooting tips, installation
videos and more
CAN ICES-3 (B)/NMB-3(B)
Notes:
The Alarm.com T r i m I I P r o
Doorbell Camera will flash Blue before it flashes Yellow –
do not release during the flashing Blue phase (this will power
cycle the device). You can factory reset the device when it is in AP
Mode (see instructions above). Press and HOLD the Main Button
until the LED flashes Yellow. If a factory reset is performed on a
camera that is already connected to Wi-Fi, the camera will need to
be re-installed to re-establish its Wi-Fi connection.