User's Manual

SkyBitz GLS 400/410 Mobile Terminal Battery Replacement Procedure
SkyBitz GLS 400/410 Mobile Terminal Battery Replacement Procedure Version 1.3
12 March 2010
6. Carefully install the battery door/tray unit firmly into the unit, applying even pressure to the left and right
sides of the door as the o-rings engage.
7. Ensure that the battery door is now firmly seated into the MT. Tighten the battery door/tray unit screws
alternately until both are fully seated. DO NOT TIGHTEN ONE SIDE FULLY AND THEN THE OTHER.
DOING SO WILL INVALIDATE THE WARRANTY.
8. Fully tighten each TORX screw to 2.5 inch pounds. EXCEEDING THE TORQUE SPEC WILL VOID THE
MOBILE TERMINAL WARRANTY AND MAY CAUSE FAILURE OF THE MOBILE TERMINAL.
9. After completing the above procedure please log into SkyBitz InSight and under Manage Settings go to
Battery Replacement and use the asset ID or MT serial number to update the battery information. You may
also contact Customer Care at 1-866-875-9248 to notify us of the replacement.
Note: Failure to properly tighten the battery door/tray unit screws will
void the warranty.
SkyBitz Customer Care at 1-866-875-9248