User's Manual

Q & A
1. Can the remote control install other apps?
The permissions of the remote control are all open, and there is no special software or restricted
software installation and uninstallation.
2. How does the remote control enter the fast charge mode?
Only under using the original charger to enter the fast charge mode, and there is a text prompt
on the lock screen interface
3. How to get the RTSP address when using MIPI or HDMI camera
Open the H16 helper, open the video to view, click on the settings (virtual button), click on the
video stream address, click on custom to copy the link below that starts with RTSP. Then paste
4. Data transmission/telemetry cannot be connected
Check whether the ground station is connected with UDP type to connect to the TX and whether
the listening port is 14551. Check whether the baud rate is normal. Check if RX and TX is
connected reversely (connect RX to TX TX to RX correctly)
5. The video/image cannot be displayed after connecting to the webcam
The video/image transmitted through the network port has a dedicated RTSP address. Not
compatible with MIPI/HDMI. This RTSP address needs to be consulted with the webcam
manufacturer
6. The remote control's network port cannot be connected to the Internet
Please turn off WIFI when connecting 5G network card or network port
7. The remote control cannot connect to WIFI
The remote control can only connect to the 5G band WIFI, and the mobile phone can change the
hotspot to the 5G band hotspot
8. Unable to share data/telemetry or video transmission
②
③