Owners manual

03-08 Dodge 2500 / 3500

4WD

Heavy Duty OEM

Steering Stabilizer

Installation Instructions

I-7013 REV1 1-12 Pg 1

Before beginning the installation, thoroughly & completely read these instructions. Please refer to

the Parts List to insure that all parts & hardware are received prior to the disassembly of the vehicle.

If any parts are found to be missing, contact SKYJACKER

Customer Service at 318-388-0816 to

obtain the needed items. If you have any questions or reservations about installing this product,

contact SKYJACKER

Technical Assistance at 318-388-0816.

REQUIRED TOOL LIST:

• Safety Glasses

• Metric / Standard Wrenches & Sockets

• Torque Wrench

www.skyjacker.com

Component Box Breakdown:

Part #: 7013

Hardware Bag Breakdown:

Part # HB-7013

Item # Description Qty Item # Description Qty

HOURGLASS 5/8 HOURGLASS 5/8 SHOCK BUSH 2 12FTN 1/2-20 FINE N/I LOCK NUT 1

142121 ES24 SLEEVE, 1.38" LONG 1 81004 TAPERED SLEEVE, 1/2"I.D. 1

141509 ES25 SLEEVE, 1.50" LONG 1 12SAEW 1/2 SAE WASHER 1

58SP 5/8" SPACER - 1 1/4" O.D. 1 12USSW 1/2 USS WASHER 1

12X412FTB 1/2 X 4 1/2 FINE THREAD BOLT 1

Item # Description Qty Item # Description Qty

7000WS WHITE STEERING DAMPER 1 B10RS RED BOOT 1

HB-7013 HARDWARE BAG FOR 7013 1 BTIE RED BOOT TIE 1

HSS HYDRO SHOCK DECAL 1 I-7013 INST. SHEET FOR 7013 1

Installation:

1. With the vehicle on at level ground, set the emergency brake & block the rear tires.

2. Remove the OEM steering stabilizer from the OEM drag link & axle.

3. Insert the polyurethane bushing & the longer sleeve (Part # 54314) into the piston end of the new

Skyjacker steering stabilizer.

4. Insert the polyurethane bushing & the shorter sleeve into the body end of the new Skyjacker

steering stabilizer.

PAGE 1
03-08 Dodge 2500 / 3500 4WD Heavy Duty OEM Steering Stabilizer Installation Instructions www.skyjacker.com Required Tool List: • Safety Glasses • Metric / Standard Wrenches & Sockets • Torque Wrench Before beginning the installation, thoroughly & completely read these instructions. Please refer to the Parts List to insure that all parts & hardware are received prior to the disassembly of the vehicle.
PAGE 2
5. Install the shock boot to the new Skyjacker steering stabilizer & secure with the supplied plastic tie. 1/2" x 4 1/2" Bolt 6. Install the piston end of the new Skyjacker steering stabilizer to the OEM drag link using the supplied hardware. (Photo # 1) 7. Insert the tapered sleeve into the tapered hole of the drag link, place the smaller 1/2" washer on the 1/2" x 4 1/2" bolt, & install through the OEM drag link hole.