User guide

ManualsBrandsSkyjacker ManualsCar7217

#7217 Steering Stabilizer

INSTALLATION INSTRUCTIONS

#I-7217 (Rev. 1/02)

ITEM PART # DESCRIPTION QTY.

7000WS STEERING DAMPER, WHITE 2

B10R RED BOOT 2

BTIE BOOT TIE STRAP 2

7217-MB MAIN BRACKET FOR FRAME 1

7217-FP FLAT PLATE BRACKET FOR DRAG LINK 1

HB-7217W HARDWARE BAG: 1

CONSISTING OF:

12X212FTB 1/2 X 2

⁄2” FINE THREAD BOLT 1

12X3FTB 1/2 X 3” FINE THREAD BOLT 2

12X4FTB 1/2 X 4” FINE THREAD BOLT 1

12FTN 1/2” FINE THREAD NUT 4

12SAEW 1/2” SAE WASHER (SMALL WASHER) 6

12USSW 1/2” USS WASHER (LARGE WASHER) 4

516X114X134 5/16 X 1

⁄4 X 1

⁄4” U-BOLT, ROUND 1

516SAEW 5/16” SAE WASHER 2

516FTN 5/16” FINE THREAD NUT 2

54314 141509 STEEL SLEEVE 2

81004 TAPERED SLEEVE 1

P932 140629 STABILIZER STUD PAK 2

HOURGLASS 5/8 SHOCK EVE BUSHING 4

PARTS BREAKDOWN

NOTES: Refer to PHOTO #1 during installation. The photo shows an application

with SKYJACKER’s

5” suspension system using a drop pitman arm (drag link is

installed to the bottom of pitman arm); however, this dual steering stabilizer kit will also

work with the original pitman arm, and a lift kit is not required.

1. To install new dual steering stabilizer insert

a poly bushing into each eye of both

stabilizers, and insert a steel sleeve only in

the eyes connected to the body (not on the

end of the shaft). Position poly boot onto

stabilizers and secure with tie straps

provided.

2. Remove original steering damper from

vehicle. Install main bracket to original frame

mount on passenger side by inserting a

⁄2” X 3” bolt with a small

⁄2” washer through

original mount, new bracket and stabilizer

using another small

⁄2” washer with self-

locking nut and tighten.

Application: 94-97 4WD Dodge Ram

PHOTO #1

Summary of content (2 pages)

PAGE 1
#7217 Steering Stabilizer INSTALLATION INSTRUCTIONS Application: 94-97 4WD Dodge Ram PARTS BREAKDOWN ITEM PART # 7000WS B10R BTIE 7217-MB 7217-FP DESCRIPTION STEERING DAMPER, WHITE RED BOOT BOOT TIE STRAP MAIN BRACKET FOR FRAME FLAT PLATE BRACKET FOR DRAG LINK QTY.
PAGE 2
3. Be sure bracket is perpendicular to the ground with tab flush against side of frame. Now drill a 1⁄2” hole through frame and insert 1⁄2” X 4” bolt with a large 1⁄2” washer with self-locking nut and tighten. 4. To install the flat bracket on the drag link, position bracket so that when the three large holes from a straight vertical line “I” the two small holes are on the driver side (with upper hole of the two small holes angling in toward the center of the bracket “\”). See photo #2. 5.